Sharp PG-B10S Operation Manual - Page 22
Projection, Image Projection, Turning the Projector - reset
![]() |
UPC - 074000364080
View all Sharp PG-B10S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Image Projection Turning the Projector on Connect the required external equipment to the projector before carrying out the following procedures. (See page 50.) Info • The language preset at the factory is English. If you want to change the on-screen display to another language, reset the language according to the procedure on page 48. 1 Plug the power cord into the wall outlet. • The power indicator illuminates red, and the projector enters standby mode. 2 Press on the projector or on the remote control. • The power indicator illuminates green. • After the lamp indicator illuminates, the projector is ready to start operation. Power indicator ON button Lamp indicator Note • The lamp indicator illuminates, indicating the status of the lamp. Green: The lamp is ready. Blinking in green: The lamp is warming up. Red: The lamp should be replaced. • If the projector is put into the standby mode and immediately turned on again, the lamp indicator may take some time to illuminate. • When "Anti-Theft" is set, the keycode input box will appear. Enter the keycode. For details about the Anti-Theft function, refer to "Anti-Theft (Setting the AntiTheft)" on page 46. • When bringing the image into focus or adjusting the projection image size, see page 22. • When adjusting the projection angle, see "Using the Adjustment Feet" on page 23 or "Variable Lens Shift Feature" on page 24. MKeycode input box ON button -18
![](/manual_guide/products/sharp-pgb10s-operation-manual-52e2a66/22.png)