Sharp PG-C20XE Operation Manual - Page 19
Operation, Basic Operations - projector lamp
View all Sharp PG-C20XE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Operation Operation Basic Operations Maintenance indicators ON/OFF POWER LAMP TEMP. KEYSTONE Projector ON/OFF POWER LAMP TEMP. KEYSTONE INPUT AUTO SYNC BACK ENTER MENU Remote control 2 Maintenance indicators ON/OFF POWER LAMP TEMP. KEYSTONE 1 Make the necessary connections before proceeding. Connect the power cord to a wall outlet. The POWER indicator illuminates red and the projector enters standby mode. • If the side filter cover is not securely installed, the POWER indicator flashes. 2 Press ON/OFF on the projector or POWER on the remote control for over one second. • The flashing green LAMP REPLACEMENT indicator shows that the lamp is warming up. Wait until the indicator stops flashing before operating the projector. • The power cannot be turned off for one minute after the power is turned on. • If the power is turned off and then immediately turned on again, it may take a short while before the lamp turns on. • After the projector is unpacked and turned on for the first time, a slight odour may be emitted from the exhaust vent. This odour will soon disappear with use. • Do not press any buttons before the startup image disappears. Before "Adjusting The Image" appears, only ON/OFF or POWER is available. When the power is on, the LAMP REPLACEMENT indicator lights indicating the status of the lamp. Green: Lamp is ready. Flashing green: Warming up. Red: Change the lamp. 16