Sharp PN-H801 Operation Manual - Page 8

MOUNTING PRECAUTIONS • This product is for use indoors. • A mounting bracket compliant with VESA specifications is required. • Since the monitor is heavy, consult your dealer before installing, removing or moving the monitor. • Mounting the monitor on the wall requires special expertise and the work must be performed by an authorized SHARP dealer. You should never attempt to perform any of this work yourself. Our company will bear no responsibility for accidents or injuries caused by improper mounting or mishandling. • Use the monitor with the surface perpendicular to a level surface. If necessary, the monitor may be tilted up to 20 degrees upward or downward. • When moving the monitor, be sure to hold it with the handles, the unit bottom and sides. Do not grasp the screen and corners. This may cause product damage, failure, or injury. • This monitor should be used at an ambient temperature between 32°F (0°C) and 104°F (40°C). Provide enough space around the monitor to prevent heat from accumulating inside. For the monitor in landscape orientation 7-7/8 [200] Unit: inch [mm] 1-7/16 [35] • Adhere to the following when installing the monitor in its portrait orientation. Failing to adhere to the following may cause malfunctions. - Install the monitor such that the power LED is located on the bottom side. - Set the MONITOR on the MONITOR menu to PORTRAIT. (See page 28.) • Even when the ambient temperature is 104°F (40°C) or less in a portrait installation, the brightness of the backlight may automatically decrease if the temperature inside the monitor becomes too hot. This is to prevent further heating of the interior. • Use the supplied sticker. For the monitor in landscape orientation Horizontal sticker (Logo) For the monitor in portrait orientation 2 2 [50] [50] 2 [50] For the monitor in portrait orientation Unit: inch [mm] 7-7/8 [200] 1-7/16 [35] 2 2 [50] [50] 2 [50] Power LED • If it is difficult to provide sufficient space for any reason such as the installation of the monitor inside a housing, or if the ambient temperature may be outside of the range of 32°F (0°C) to 104°F (40°C), install a fan or take other measures to keep the ambient temperature within the required range. • Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such cases, please check the temperature condition specified by the optional equipments. • Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a malfunction. • Do not place the monitor on a device which generates heat. Vertical sticker (Operation panel) Be careful not to cover the remote control sensor or switches. E8