Sharp R-21LC Owners Manual for R-21LC - Page 16

Care And Cleaning

Page 16 highlights

CARE AND CLEANING VERY IMPORTANT CAUTIONS *DO NOT OPERATE the oven without the splash covers in place. *DO NOT REMOVE the ceramic shelf from the oven. *DO NOT OPERATE the oven without the air ventilation cover. *DO NOT USE commercial oven cleaners, abrasive or harsh cleaners or scouring pads on any part of your microwave oven. Oven exterior The outside of your oven can be easily cleaned with mild soap and water. Make sure to rinse thoroughly and dry the exterior with a soft towel. Control panel Care should be taken in cleaning the control panel. Open the door before cleaning to inactivate the control panel pads. Using a cloth dampened with water only, gently wipe the panel until it becomes clean. Avoid the use of excess water. Do not use any sort of chemical or abrasive cleaner. To do so may cause severe damage to the panel and make programming impossible. Caution for R-21LC: Take care not to move the Light Up Dial from "0" during cleaning, or the oven will start as soon as you close the door. Oven interior 1) For easy cleaning, wipe any spatters or spills with a soft damp cloth or sponge at the end of each day. For heavier spills, use mild soap and rinse thoroughly with hot water. 2) At least once a week, remove the splash covers and wash in a mild detergent solution. The splash covers are located on the back wall near the top of the oven and on the right side wall. The covers may be removed easily. Simply remove four clips (A) as shown in Fig. 1. Then remove the splash covers from the oven. Door Fig.1 Back splash cover (B) To replace the back splash cover (B), secure the cover to the oven side walls with two clips (A) as shown in Fig.1. To replace the side splash cover (C), insert two projections of the cover (C) into the holes of the oven right wall as shown in Fig 2. And secure the cover to the oven right wall with two clips (A) as shown in Fig 1. Fig.2 Side splash cover (C) 3) Wipe any grease, spills or spatters on the door seal surfaces with a soft damp cloth or sponge so that they do not build up. The door seals must always be free of grease and spatters so that the door closes properly. Door Wipe the door and window on both sides frequently with a damp cloth to remove any spills or spatters. Always keep the door seals and seal surfaces clean so that any grease, spills or spatters are not allowed to build up. Such a build-up could result in leakage of microwave energy from the oven. (A) (A) (A) (A) Side splash cover (C) 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

15
Side splash cover (C)
To replace the back splash cover (B),
secure
the cover to the oven side walls with two clips
(A) as shown in Fig.1.
To replace the side splash cover (C), insert two
projections of the cover (C) into the holes of the
oven right wall as shown in Fig 2. And secure
the cover to the oven right wall with two clips
(A) as shown in Fig 1.
3)
Wipe any grease, spills or spatters on the door
seal surfaces with a soft damp cloth or sponge
so that they do not build up. The door seals
must always be free of grease and spatters so
that the door closes properly.
Door
Wipe the door and window on both sides fre-
quently with a damp cloth to remove any spills or
spatters. Always keep the door seals and seal
surfaces clean so that any grease, spills or spat-
ters are not allowed to build up. Such a build-up
could result in leakage of microwave energy from
the oven.
CARE AND CLEANING
VERY IMPORTANT
CAUTIONS
*DO NOT OPERATE the oven without the
splash covers in place.
*DO NOT REMOVE the ceramic shelf from the
oven.
*DO NOT OPERATE the oven without the air
ventilation cover.
*DO NOT USE commercial oven cleaners,
abrasive or harsh cleaners or scouring pads
on any part of your microwave oven.
Oven exterior
The outside of your oven can be easily cleaned
with mild soap and water. Make sure to rinse
thoroughly and dry the exterior with a soft towel.
Control panel
Care should be taken in cleaning the control
panel. Open the door before cleaning to inactivate
the control panel pads.
Using a cloth dampened with water only, gently
wipe the panel until it becomes clean. Avoid the
use of excess water. Do not use any sort of
chemical or abrasive cleaner. To do so may cause
severe damage to the panel and make program-
ming impossible.
Caution for R-21LC:
Take care not to move the Light Up Dial from "0"
during cleaning, or the oven will start as soon as
you close the door.
Oven interior
1)
For easy cleaning, wipe any spatters or spills
with a soft damp cloth or sponge at the end of
each day. For heavier spills, use mild soap and
rinse thoroughly with hot water.
2)
At least once a week, remove the splash covers
and wash in a mild detergent solution. The
splash covers are located on the back wall near
the top of the oven and on the right side wall.
The covers may be removed easily. Simply
remove four clips (A) as shown in Fig. 1. Then
remove the splash covers from the oven.
Back splash cover (B)
Door
Side
splash
cover (C)
(A)
(A)
(A)
(A)
Fig.2
Fig.1