Sharp SW340 CD-SW340 Operation Manual - Page 28

CD-SW340 Listening to a cassette tape (TAPE 1 or TAPE 2) Before playback: For playback, use normal or low-noise tapes for the best sound. (Metal or CrO tapes are not recommended.) Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions. Before loading a tape into the cassette compartment, tighten the slack with a pen or a pencil. POWER ON/ STAND-BY TIMER CD 5 4 3 2 1 Tape playback 1 Press the ON/STAND-BY button to turn the power on. 2 Open the cassette compartment by pushing the area marked " ". CD PRESET TUNING - VOL. 5 4 3 PRESET 2 1 VOL. TUNING PLAYBACK (PLAY & STOP) PHONES RT RECORD/PLAYBACK CD TAPE 1/2 TUNER(BAND) AUDIO IN PRESET TUNING - VOL. PUSH EJECT PLAYBACK (PLAY & STOP) PHONES MUSIC PORT OPEN/CLOSE 5 4 3 PRESET 2 1 VOL. TUNING PUSH EJECT RECORD/PLAYBACK 3 Load a cassette into the TAPE 1 compartment or TAPE 2 compartment with the side to be played facing toward you. CD PRESET TUNING - VOL. 5 4 3 PRESET 2 1 VOL. TUNING PLAYBACK (PLAY & STOP) PHONES RECORD/PLAYBACK 4 Press the TAPE (1 want to listen to. TAPE 1 TAPE 2 2) button to select the cassette you Tape Playback PRESET PLAYBACK (PLAY & STOP) PHONES AUDIO IN RECORD/PLAYBACK PRESET 5 Press the / (TAPE ) to start playback. Tape play indicator Auto power on function: When you press any of the following buttons, the unit turns on. TAPE (1 2) button (main unit and remote control): The unit turns on and the "TAPE" function is activated. TAPE button (remote control): The unit turns on and the "TAPE" function is activated. / button (main unit): The unit turns on and playback of the last function starts (CD,TAPE,TUNER,AUDIO IN). Auto power off function: In the stop mode of tape operation, the main unit enters the stand-by mode after 15 minutes of inactivity. 28