Sharp XG-PH70X XG-PH70X Operation Manual - Page 107

Specifications Product type Multimedia Projector Model XG-PH70X (standard zoom lens attached)/XG-PH70X-N (no lens attached) Video system NTSC3.58/NTSC4.43/PAL/PAL-M/PAL-N/PAL-60/SECAM/ DTV480I/DTV480P/DTV540P/DTV576I/DTV576P/DTV720P/DTV1035I/DTV1080I Display device 0.7" DLP® chip × 1 No. of dots: 786,432 dots (1,024 [H] × 768 [V]) Standard zoom lens 1.2 × electric zoom/focus lens, F1.8-F2.0, f = 25.6-31.3 mm (standard equipment with XG-PH70X) Projection lamp 260 W × 2 Component input (INPUT 1)/ 15-pin mini D-sub connector output (OUTPUT) signal Y: 1.0 Vp-p, sync negative, 75 Ω terminated PB: 0.7 Vp-p, 75 Ω terminated PR: 0.7 Vp-p, 75 Ω terminated Horizontal resolution 750 TV lines (DTV720P) Component input (INPUT 2) BNC connector signal Y: 1.0 Vp-p, sync negative, 75 Ω terminated PB: 0.7 Vp-p, 75 Ω terminated PR: 0.7 Vp-p, 75 Ω terminated RGB input (INPUT 1/2)/output 15-pin mini D-sub connector, 5 BNC connector: RGB separate/composite sync (TTL)/sync (OUTPUT) signal on green type analog input: 0-0.7 Vp-p, positive, 75 Ω terminated Horizontal sync. signal: TTL level (positive/negative) or composite sync (Apple only) Vertical sync. signal: Same as above RGB digital input signal (INPUT 3) DVI connector (24-pin), RGB (digital), 250 -1,000 mV, 50 Ω (Compatible with HDCP) Video input signal RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Ω (INPUT 4) terminated S-video input signal 4-pin mini DIN connector (INPUT 5) Y (luminance signal): 1.0 Vp-p, sync negative, 75 Ω terminated C (chrominance signal): Burst 0.286 Vp-p, 75 Ω terminated Audio input signal ø3.5 mm stereo minijack, RCA terminal 0.5 Vrms, more than 22 kΩ Audio output signal ø3.5 mm minijack (AUDIO OUTPUT 1-5) 0.5 Vrms, less than 2.2 kΩ RS-232C terminal 9-pin D-sub connector LAN terminal 8-pin RJ-45 modular connector Pixel clock 12-230 MHz Vertical frequency 43-200 Hz Horizontal frequency 15-126 kHz Audio output 3.0 W (stereo) Speaker system 3.3 cm round × 2 Rated voltage AC 100-240 V Input current 6.6 A (AC 100 V)-2.7 A (AC 240 V) Rated frequency 50/60 Hz Power consumption 650 W (when "Eco Mode" is "OFF")/570 W (when "Eco Mode" is "ON") with AC 100 V 620 W (when "Eco Mode" is "OFF")/550 W (when "Eco Mode" is "ON") with AC 240 V Power consumption (standby) 0.8 W (AC 100 V) - 1.1 W (AC 240 V) (When "Monitor Out" and "LAN/RS232C" are set to "Disable".) Heat dissipation 2,440 BTU/hour (when "Eco Mode" is "OFF")/2,140 BTU/hour (when "Eco Mode" is "ON") with AC 100 V 2,330 BTU/hour (when "Eco Mode" is "OFF")/2,070 BTU/hour (when "Eco Mode" is "ON") with AC 240 V Operating temperature 41°F to 104°F (+5°C to +40°C) Storage temperature -4°F to 140°F (-20°C to +60°C) Cabinet Plastic I/R carrier frequency 38 kHz Dimensions (approx.) 16 5/32" × 7 3/32" × 18 35/64" (410 (W) × 180 (H) × 471 (D) mm) (main body only) 16 5/32" × 7 37/64" × 18 35/64" (410 (W) × 192.1 (H) × 471 (D) mm) (including adjustment foot and projecting parts) Weight (approx.) XG-PH70X: 32.9 lbs. (14.9 kg) XG-PH70X-N: 30.3 lbs. (13.7 kg) Replacement parts Remote control, Power cord for U.S., Canada, etc., Power cord for Europe, except U.K., Power cord for U.K., Hong Kong and Singapore, Power cord for Australia, New Zealand and Oceania, RGB cable, Remote mouse receiver, Cap for the standard zoom lens, Projector manual and technical reference CD-ROM, Operation manual As a part of policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. -105 Appendix