Sharp XG-V10XU XG-V10XU Operation Manual - Page 20
Power ON/OFF, Turning on the Main Power
View all Sharp XG-V10XU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Power ON/OFF Turning on the Main Power Press the MAIN POWER switch on the side of the projector. The POWER indicator lights up red and the projector enters standby mode. • When the main power is not on, the remote control cannot be used to operate the projector. Setup & Connections TEMP LAMP2 LAMP1 POWER 2 1 POWER buttons 1.2.3 4.5.6 TEMP LAMP2 LAMP1 POWER 2 1 Conference Series E-19 Press POWER ON. • The flashing green LAMP REPLACEMENT indicator shows that the lamp is warming up. Wait until the indicator stops flashing before operating the projector. • If the power is turned off and then immediately turned on again, it may take a short while before the lamp turns on. • After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust vent. This odor will soon disappear with use. When the power is on, the LAMP REPLACEMENT indicator lights, indicating the status of the lamp. Green: Lamp is ready. Flashing green: Warming up. Red: Change the lamp. • When setting the lamp mode to "Lamp 1 only" or "Lamp 2 only", only the LAMP REPLACEMENT indicator corresponding to the lamp set is lit. Press POWER OFF. Press POWER OFF again while the message is displayed. • If you accidentally pressed POWER OFF and do not want to turn off the power, wait until the power off screen disappears. • When POWER OFF is pressed twice, the POWER indicator will light up red and the cooling fan will run for about 90 seconds. The projector will then enter standby mode. • Wait until the cooling fan stops before disconnecting the power cord. • The power can be turned on again by pressing POWER ON. When the power is turned on, the POWER indicator and the LAMP REPLACEMENT indicators light green. • The POWER indicator flashes if the front filter is not securely installed.