Sharp XG-V10XU XG-V10XU Operation Manual - Page 72
Setting the Lamp Mode, Replacing the Lamp, Lamp Mode
View all Sharp XG-V10XU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Setting the Lamp Mode Projector Remote Control 1, 6 2, 3, 4 5 1.2.3 4.5.6 (GUI) On-screen Display This function can be used to set the lamp mode. The mode can be set to double the effective lamp usage time. Description of Lamp Mode Selected item Description Both Lamps Both lamps are used for greater brightness. Lamp 1 Only Lamp 2 Only Lamp 1 is used. When lamp 1 burns out, automatically switches to lamp 2. Lamp 2 is used. When lamp 2 burns out, automatically switches to lamp 1. Equal Use Both lamps are used alternatingly. Switches after every 100 hrs. of use. (Slide the MOUSE/ADJUSTMENT switch MOUSE ADJ. on the remote control to the ADJ. position.) 1 Press MENU. 2 Press ß/© to select "Options (2)". 3 Press ∂/ƒ to select "Lamp Mode", and then press ©. 4 Press ∂/ƒ to select the desired Lamp Mode. 5 Press ENTER to save the setting. 6 To exit from the GUI, press MENU. • In "Equal Use" mode, when the projector is used for more than 24 hrs. continuously, it switches in shift of 100 hrs. Replacing the Lamp CAUTION • Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center for a replacement. • Do not remove the lamp cage directly after operation of the projector. The lamp may be extremely hot. Wait at least one hour after the power cord is disconnected to allow the surface of the lamp cage to fully cool before removing the lamp cage. It is recommended that the lamp be replaced after approximately 900 cumulative hours of use or when you notice a significant deterioration of the picture and color quality. Carefully change the lamp by following the steps on the next page. If the new lamp does not light after replacement, take your projector to the nearest Authorized Sharp Industrial LCD Products Dealer or Service Center for repair. Purchase a replacement lamp unit (lamp/cage module) of the current type BQC-XGV10WU/1 from your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center. Then carefully change the lamp by following the instructions on the next page. If you wish, you may have the lamp replaced at your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center. IMPORTANT NOTE TO U.S. CUSTOMERS: The lamp included with this projector is backed by a 90-day parts and labor limited warranty. All service of this projector under warranty, including lamp replacement, must be obtained through an Authorized Sharp Industrial LCD Products Dealer or Service Center. For the name of the nearest Authorized Sharp Industrial LCD Products Dealer or Service Center, please call toll-free: 1-888-GO-SHARP (1-888-467-4277). U.S.A. ONLY Maintenance & Troubleshooting E-71