Sharp XL-1200 XL1200 Operation Manual - Page 17

Setting the Clock 3 Within 1 minute, press the PRESET ( or ) button to adjust the hour and then press the MEMORY button. Basic Operation - Setting the Clock - This may be operated only with the remote control. In this example, the clock is set for the 12-hour (AM 12:00) display. 1 Press the CLOCK button and within 3 seconds, press the MEMORY button. 2 Within 1 minute, press the PRESET ( or ) button to select 12-hour or 24-hour display and then press the MEMORY button. "AM 12:00" The 12-hour display will appear. (AM 12:00 - PM 11:59) "0:00" The 24-hour display will appear. (0:00 - 23:59) Note that this can only be set when the unit is first installed or it has been reset. (Refer to step 3 under "If trouble occurs" on page 30.) z When the 12-hour display is selected, "AM" will change automatically to "PM". 4 Within 1 minute, press the PRESET ( or ) button to adjust the minutes and then press the MEMORY button. z The hour will not advance even if minutes advance from "59" to "00". z The clock starts from "0" second. (Seconds are not displayed.) To confirm the time display when the power is on: Press the CLOCK button. The time display will appear for about 5 seconds. Note: The time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit. Readjust the clock as follows. To readjust the clock: Perform "Setting the Clock" from the beginning. To change the 12-hour or 24-hour display: 1 Clear all the programmed contents. [Perform to step 3 under "If trouble occurs" on page 30 for details.] 2 Perform "Setting the Clock" from the beginning. 17 01/2/19 XL-1200(U)2.fm