Singer 1 One Instruction Manual 26 - Page 20
the tension discs and pull thread down to make
View all Singer 1 One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
While holding thread with finger, pass it between the tension discs and pull thread down to make certain it is properly located in between the tension discs 3. 3 3 Turn the hand wheel toward you until the lower looper extends out 5~10mm from the needle plate edge. Thread the looper area of the machine following the red color coded thread guides 4~10. Note: Use tweezers provided in the accessory case to aid in threading the looper. Place the thread with the point of the tweezers slightly from left and to the right of threading guide 4. Place the thread with the point of the tweezers slightly from front and to the back of threading guide 5. 10 9 8 7 4 5 6 4 8 5 7 6 Thread the looper eye (A) from front to back. Pull about 10cm (4 inches) of thread. Position thread into V cutout (B) on threader. Firmly hold thread tail with left hand and pull Threader lever (C) up into place (D). 9 A 10 D B C 19