Singer CE-350 Futura Instruction Manual - Page 42

BLIND STITCH SETTINGS :Presser foot - Blind Hem Foot :Thread tension control - S - E - Regular blind stitch for normal fabrics 1 2 Medium to heavyweight fabric Material de peso medio a pesado Tissus moyens et lourds - Elastic blind stitch for soft, stretchable fabrics Reminder: Patterns for blind hemming must be mirror imaged. 1. First finish the raw edge. Do this by turning it under on fine fabrics or overcasting it on medium to heavyweight fabrics. Then turn the hem up the required depth, press and pin in place. 2. Now fold the fabric as illustrated. Under side Reverso Envers 1 Under side Reverso Envers 2 Fine fabric Material fino Tissus fins Under side Reverso Envers Under side Reverso Envers B 3. Place the fabric under the foot. Turn the handwheel towards 3 you by hand until the needle swings fully to the left. It should just pierce the fold of the fabric. If it does not, adjust the guide A (B) on the Blindhem Foot (A) so that the needle just pierces the fabric fold and the guide just rests against the fold. NOTE: For a narrower or wider blindhem, first manually adjust the length and width controls to your desired length and width. Then adjust the guide on the foot. Sew slowly, guiding the fabric carefully along the edge of the guide. 4. When completed, the stitching is almost invisible on the right side of the fabric. NOTE: It takes practice to sew blind hems. Always make a sewing test first. 4 Top side Cara Endroit SHELL STITCH SETTINGS :Presser foot - Zigzag foot :Thread tension control - S - E Turn under the raw edge and press. Place the fabric right side up so that the zigzag part of the stitch sews just over the folded edge, pulling the fabric in to form a shell hem. Trim away excess fabric close to the stitching line. 42