Singer Futura XL-400 Instruction Manual - Page 78
Operation Switches When, Embroidery Unit Is Attached - sewing machine hoops
View all Singer Futura XL-400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
OPERATION SWITCHES WHEN EMBROIDERY UNIT IS ATTACHED OPERATION SWITCHES START/STOP BUTTON When start/stop button is pushed, machines starts slowly. To stop the machine, push the button again and the machine will stop sewing and the needle stops at its highest position. FORWARD STITCH BUTTON After the embroidery design has been transferred to the machine, the embroidery can be advanced one stitch at a time. Note: The embroidery hoop will move as it is advancing through the design. To advance continuously, press and hold this button. REVERSE STITCH BUTTON To back up through a design that is already in progress, press the Reverse Stitch button. Pressing the button once will reverse one stitch at a time. To reverse continuously, press and hold this button. Design may be reversed all the way back to the first stitch of the design. LED INDICATOR Green light indicates machine is ready to start. Red light indicates machine is operating. Flashing red light indicates a problem or an error. * Flashing for 2 - 3 seconds shows that an incorrect operation was made. * Continuous flashing indicates that the machine malfunctions. LED indicator Témoin a diode Indicador LED Forward stitch button Interupteur couture avancé Interruptor de puntadas hacia adelante Reverse stitch button Interrupteur couture arrière interruptor de puntadas hacia atrás Start/stop button (For embroidery only) Interrupteur marche/arrêt (Pour la broderie seulement) Pulsador de comienzo/parada (Sólo para bordado) THREAD TENSION CONTROL Set it at "E" for embroidery to loosen thread tension. You may wish to re-adjust thread tension according to the type of fabric and thread being used. NOTE: When sewing designs created by the software for Photo Stitch (optional) it is recommended to decrease the thread tension toward "0" and activate the "Speed limiter", by checking the box in Machine navigator, before sending the design to the machine. This ensures the best performance of the machine. 76