Smeg EGF03BLUS Instruction manual - Page 26
Problem, Possible causes, Solution
View all Smeg EGF03BLUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
What to do if... Problem Possible causes No water in the tank (7). The keys (13-14) flash. The filter holes (11-12-1314) are blocked. The tank (7) is not inserted correctly or is empty. Solution Fill the tank (7). Clean the filter (11-12-1314) with a brush or the pin supplied. Insert the tank (7) correctly and make sure it contains water. No coffee is dispensed from the nozzles. Lime scale build-up. Perform a descaling cycle. The manometer indicates an over-pressure. The ground coffee is too fine. Excessive tamping. Make the coffee again introducing less powder or coarser powder. Adjust grinding level to a thicker level. Use less coffee. You are using too much coffee. The coffee drips from the filter-holder (20) and not from the nozzles. The filter-holder (20) is not attached correctly or is dirty. The dispensing unit gasket is worn. The nozzle holes are blocked. The filter holder (20) will The filter has been not attach to the coffee overfilled. machine. The coffee machine does not work and all the LEDS flash. Possible fault. The coffee is light in colour and comes out of the nozzle quickly. The ground coffee has not been tamped sufficiently. There is insufficient ground coffee. The ground coffee is too coarse. Reduce the amount of coffee. Attach the filter-holder (20) and rotate it fully home. Clean the filter-holder (20). Have it replaced at an authorised After-sales Centre. Clean the nozzle holes. Check the amount of coffee dosed. Unplug the coffee machine and contact an Authorised After-sales Centre. Tamp the coffee harder. Increase the amount. Set grind to a finer level. EN - 20