Sony BRCH700 Operating Instructions - Page 39

Operation Using the Supplied Remote Commander Operation Using the Supplied Remote Commander Before operating, check that the camera and peripheral devices are properly installed and connected. For details, see "Installation" (page 50) and "Connections" (page 57). Turning on the Power 1 2 3 4 5 6 7 8 9 VISCA RS-422 OFF ON 75 IN VISCA RS-232C OUT EXT SYNC IN R DC IN 12V 1 2 3 IR SELECT OFF ON DATA MAX RGB/COMPONENT to AC outlet POWER lights. 1 Connect the camera to an AC outlet using the supplied AC power adaptor and power cord. The power is turned on and the POWER lamp lights. The camera will automatically pan and tilt and be reset to the position stored in POSITION 1 (Pan/tilt reset action). 2 Turn on the peripheral devices. To turn on/off the camera using the Remote Commander As long as the camera is connected to an AC outlet, you can turn the camera on or off with the POWER switch on the Remote Commander. When you turn the power off using the Remote Commander, the POWER lamp turns off and the STANDBY lamp lights on the camera. POWER CAMERA SELECT 1 2 3 AUTO FOCUS MANUAL FAR NEAR DATA SCREEN BACK LIGHT POWER STANDBY lights. Pan/Tilt and Zoom Operation Panning and Tilting STD POWER 1 CAMERA SELECT 2 1 FOCUS 3 MANUAL NEAR BACK LIGHT CAMERA SELECT FAR AUTO DATA SCREEN 3 REV 2 6 STD RESET 1 4 5 PRESET POSITIOPNAN-TILT HOME REV 2 PARNE-TSIELTT PAN-TILT RESET FAST ZOOM T HOME T SLOW W W RM-EV100 DIREL/CRTION SET L/R DIRECTION SET 1 Press the POWER switch. The camera will turn on and perform the pan/tilt reset action automatically. 2 Press the arrow button to pan or tilt the camera. While checking the picture on the screen, press the desired arrow button. To move the camera little by little, press the button just for a moment. To move the camera in a wide range, press and hold the button. To move the camera diagonally, press the B or b button while holding down the V or v button. To face the camera back to the front Press the HOME button. If you accidentally move the camera with your hand Press the PAN-TILT RESET button to perform the pan/ tilt reset action. If the camera moves in a different direction from that you intended The camera is preset to face toward the right whenever the b button is pressed. You might wish to face the camera toward the opposite direction from that of the button you pressed, for example, when you change the direction of the camera while checking the picture on the screen. In such a case, press the 2 (REV) button while holding down the L/R DIRECTION SET button. To reset the setting, press the 1 (STD) button while holding down the L/R DIRECTION SET button. 39 Turning on the Power / Pan/Tilt and Zoom Operation