Sony BRCH700 Operating Instructions - Page 43
Operation Using the RM-BR300 Remote Control Unit, Turning on the Power, Operating Multiple Cameras
UPC - 027242684362
View all Sony BRCH700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Operation Using the RM-BR300 Remote Control Unit Before operating, check that the camera, the RM-BR300 Remote Control Unit and peripheral devices are properly installed and connected. For details, see "Installation" (page 50) and "Connections" (page 57). To turn on/off the camera using the RMBR300 Remote Control Unit As long as the camera is connected to an AC outlet, you can turn the camera on or off with the POWER button on the Remote Control Unit. While holding down the POWER button, press the CAMERA button corresponding to the camera whose power you want to turn on/off. When you turn the power off using the Remote Control Unit, the POWER lamp turns off and the STANDBY lamp lights on the camera. Turning on the Power Operation Using the RM-BR300 Remote Control Unit 1 2 RESET PANEL LIGHT VALUE LOCK - + R BRIGHT MODE - + B FOCUS AUTO AUTO MANUAL NEAR FAR ONE PUSH AF RESET PRESET SHIFT L/R DIRECTION POWER PANEL LIGHT BLACK LIGHT PAN-TILT ONE PUSH RESET AWB MENU POSITION 12345678 9 10 11 12 13 14 15 16 STD REV CAMERA 1234567 POWER CAMERA STANDBY lights. To illuminate the panel of the Remote Control Unit Press the PANEL LIGHT button. All the POSITION buttons and CAMERA buttons light. To turn off the illumination, press the PANEL LIGHT button again. PANEL LIGHT 1 Connect the camera to an AC outlet using the supplied AC power adaptor and power cord. The power is turned on and the POWER lamp lights. The camera will automatically pan and tilt and be reset to the position stored in POSITION 1 (Pan/tilt reset action). 2 Press the ON/OFF switch on the RM-BR300 Remote Control Unit to turn it on. The CAMERA button representing the camera whose power was turned off last lights. (The CAMERA 1 button lights by default.) 3 Turn on the peripheral devices. Note Be sure to turn on the power of the camera before the power of the Remote Control Unit. Otherwise, the Remote Control Unit cannot recognize the connected camera. Operating Multiple Cameras Before operating, you must assign the camera addresses to the connected cameras as follows. Then you can switch the camera to be controlled simply by pressing the corresponding CAMERA button. To assign camera addresses automatically 1 Make sure that the camera address selector on the bottom of each camera is set to "0." For setting the camera address selector, see page 19. 2 Turn on the power of all the connected cameras and the RM-BR300 Remote Control Unit. 43 Turning on the Power