Sony CDX-C910 Operating Instructions - Page 22

Adjusting the volume of the bass and treble You can adjust the volume of the bass and treble to best fit the acoustic characteristics inside your car. 1 Press (SOURCE) to select a source (radio, CD or MD). 2 Press (SOUND) repeatedly until "BAS" or "TRE" appears. 3 Rotate the dial to adjust the volume. After three seconds, the display goes back to the normal playback mode. Adjusting the turn-over frequency You can adjust the bass and treble turn-over frequencies. EN Turn-over frequency Frequency (Hz) 1 Press (SOURCE) to select a source (radio, CD or MD). 2 Press (SOUND) for two seconds. 3 Press (SOUND) repeatedly until "BAS" or "TRE" appears. Bass adjusting mode BAS EQ SUR 314 Hz Treble adjusting mode TRE EQ SUR 3.1kHz 4 Rotate the dial to select the turn-over frequency. The turn-over frequencies change as follows: Bass: 198 Hz n 250 Hz n 314 Hz* n 396 Hz 22 Treble: 2.0 kHz n 3.1 kHz* n 4.0 kHz n 5.0 kHz * Factory-set frequency 5 Press (SOUND) for two seconds. The display goes back to the normal playback mode. Listening to each programme source in its registered surround menu - Last Sound Memory (LSM) You can listen to the same source always in the same surround menu even after changing the programme source or turning the unit on and off again. Changing the line output level You can change the line output level if you distortion or other noise. 1 Press (SHIFT), then press (2) (SET UP) until "L.out" appears. 2 Press (4) (n) to select the desired setting (-10 dB or -16 dB). 3 Press (SHIFT). Actual total number: Sony CDX-C910 (E,S,C) 3-856-715-11 (2)