Sony CDX-GT805DX Owners manual - Page 11
Selecting to taste - SOUND, Optimizing your sound - Sound MENU, HDEQ Tuning
View all Sony CDX-GT805DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Selecting to taste - SOUND You can set up in various ways, selecting the preset of HDEQ, DSO 3D and I-TA. 1 Press (SOUND) repeatedly to select your desired item during playback. The items change as follows: HDEQ t DSO 3D t I-TA t Balance t Fader t Sub Woofer 2 Rotate the volume control dial to select the setting. After about 3 seconds, the setting is complete. With the card remote commander In step 2: press < or , to adjust tuning HDEQ, DSO 3D and I-TA precisely. See page 11 and 12 for further information. Optimizing your sound - Sound MENU You can precisely optimize the setting of HDEQ, DSO 3D and I-TA to your taste and according to your car interior, using the Sound MENU. See also "Precisely adjusting your sound" (page 13). BBE MP is also adjustable. The menu method is common to each feature - learn the procedure below, then proceed to each feature. 1 Press (MENU) during playback. 2 Rotate the SEEK control dial until "SOUND" appears. 3 Press (ENTER). 4 Rotate the SEEK control dial to select an item, then press (ENTER). 5 Repeat step 4 to adjust other items. 6 Press (MENU). The setting is complete. With the card remote commander In steps 2 and 4: press M or m to adjust the selected item. HDEQ Tuning The equalizer curve is precisely adjustable for frequency and volume level. Tuning consists of 4 channels: Front L/R and Rear L/R. 1 Select "SOUND" t "HDEQ" in MENU mode. 2 Select "Custom1," "Custom2" or "Custom3" to store. 3 Select the equalizer curve you wish to adjust. In your chosen Custom setting the equalizer curve can be adjusted, then a pencil icon will appear as "Custom1" t "Custom1 ." 4 Select the speaker to adjust. 5 Adjust the equalizer curve to your taste. 1 Press (ENTER) to select the frequency you wish to adjust (adjustable from 63 Hz to 16 kHz in 13 bands). 2 Rotate the SEEK control dial to adjust the level of the chosen frequency (1 dB steps from -6 dB to +6 dB). 3 Repeat steps 1 and 2 to adjust other bands of the equalizer curve. 6 Confirm your settings using the confirmation screen, and save the value. 7 Repeat steps 3 to 6 until all the speakers have been set. Note The pencil icon appears only after selecting the preset in step 3, however, until it is saved in step 6, the adjustment will not be applied. Tip Select "Reset" in step 4 to reset the default setting (flat). With the card remote commander In 1 of step 5: to press < or , to adjust the frequency; in step 2: press M or m to adjust the level. continue to next page t 11