Sony CMT-X3CD Operating Instructions - Page 27

Precautions/Specifications Precautions Discs that this system CAN play  Audio CD-DA discs  CD-R/CD-RW (audio data of CD-DA tracks and MP3/WMA files) Do not use a CD-R/CD-RW disc with no data stored. Doing so may damage the disc. Discs that this system CANNOT play  CD-ROM  CD-R/CD-RW other than those recorded in music CD format or MP3/WMA format conforming to ISO9660 Level 1/Level 2, Joliet  CD-R/CD-RW recorded in multi-session format and not closed the session  CD-R/CD-RW of poor recording quality, CD-R/CD-RW that have scratches or are dirty, or CD-R/CD-RW recorded with an incompatible recording device  CD-R/CD-RW which is finalized incorrectly  CD-R/CD-RW containing files other than MPEG 1 Audio Layer-3 (MP3/WMA) files  8 cm disc  Discs of non-standard shape (for example, heart, square, star)  Discs that have adhesive tape, paper, or sticker attached to them  Rental or used discs with attached seals where the glue extends beyond the seal  Discs that have labels printed using ink that feels tacky when touched Note on CD-DA/MP3/WMA discs  Before playing, wipe the disc with a cleaning cloth from the center out to the edge.  Do not clean discs with solvents, such as benzine, thinner, or commercially available cleaners or antistatic spray intended for vinyl LPs.  Do not expose discs to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight. On safety  Completely disconnect the power cord (mains lead) from the wall outlet (mains) if it is not going to be used for an extended period of time. When unplugging the system, always grip the plug. Never pull the cord itself.  Should any solid object or liquid get into the system, unplug the system, and have it checked by qualified personnel before operating it again.  The AC power cord can be changed only by a qualified service facility. On placement  Do not place the system in an inclined position or in locations that are extremely hot, cold, dusty, dirty, or humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light.  Be careful when placing the system on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result.  Do not place heavy objects on the system.  If the system is brought directly from a cold to a warm location or is placed in a very damp room, moisture may condense on the lens inside the system, and cause the system to malfunction. In this situation, remove the disc, and leave the system turned on for about an hour until the moisture evaporates. If the system still does not operate, even after an extended period, consult your nearest Sony dealer. On heat buildup  Heat buildup on the unit during charging or operation over a long period of time is normal and not cause for alarm.  Do not touch the cabinet if it has been used continuously at a high volume because the cabinet may have become hot.  Do not obstruct the ventilation holes. Cleaning the cabinet Clean this system with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pads, scouring powder, or solvents, such as thinner, benzine, or alcohol. 27GB Precautions/Specifications