Sony DSR 25 Operating Instructions - Page 52

AAuduiodDioubDbinugbbing You can record just sound on a recorded tape. (Audio dubbing) Notes • You can dub the sound onto a DVCAM-formatted tape (recorded) in the 32 kHz audio mode (4-channel/ 12 bits). You cannot dub the sound on a tape in the 48 kHz audio mode (2-channel/16 bits). If the audio mode of the recorded tape is 32 kHz, you can dub the sound regardless of the AUDIO MODE setting on the AUDIO SET menu. For details on "AUDIO MODE," see "AUDIO SET menu" on page 64 (GB). • The sound is dubbed only onto channels 3/4. You cannot dub the sound onto either of them or channels 1/2. Connection of external devices The following shows an example of a basic connection for audio dubbing. DSR-25 Headphones (front panel) 1 KEY INH ON OFF AUDIO OUTPUT SELECT CH- CH- 1/2 3/4 PHONES MIN MAX DSR-25 (rear panel) Analog video output AUDIO OUTPUT Video input Audio input Monitor Sound source Audio output AUDIO INPUT Dubbing sound 1 Connect the unit and the sound source using a phono jack cable (not supplied). 2 Set the INPUT SELECT selector to a setting other than DV. 3 Switch the AUDIO INPUT LEVEL selector to select the audio input signal level (-10, -2 or +4). 4 Play back the tape inserted in this unit. 5 At the point you want to start dubbing, press the PAUSE button to turn the unit to the playback pause mode. 6 While holding the AUDIO DUB button down, press the PLAY button to turn the unit to the audio dubbing pause mode. The AUDIO DUB indicator on this unit lights. 7 Set the AUDIO INPUT switch to FIX or VAR. Chapter 4 Duplication and Audio Dubbing 52 (GB) Chapter 4 Duplication and Audio Dubbing