Sony HCD-GSX100W Operating Instructions - Page 11

Wireless Notes • When you use the main unit inside the effective areas of the transmitter, the transmitter can be placed in any direction from the listener. • Even within the signal reception area, there are some spots (dead spot) where the RF signal cannot be received. This is a characteristic inherent to RF signals, and does not indicate a malfunction. By slightly moving the transmitter, the location of the dead spot can be changed. Notes on receiving performance This system component utilizes very high frequency signals in the 900 MHz band so the receiving performance may deteriorate due to the surroundings. The following examples illustrate conditions that may reduce the possible receiving range or cause interference with reception. - Radio waves generated such as cellphones and cordless phone systems or metal instruments are placed on the unit. - Inside a building with walls containing steel beams. - Area with many steel file cabinets, etc. - Area with many electrical appliances capable of generating electromagnetic noise. - Transmitter is placed on a metal instrument. - Area facing roadways. - Noise or interfering signals exist in the surroundings due to radio transceivers in trucks, etc. - Noise or interfering signals exist in the surroundings due to wireless communication systems installed along roadways. - Transmitter is placed directly on floor. Placing it up off the floor, such as on a desk, is recommended. Listening to audio using wireless system (MHC-GSX100W only) 1 Start playing the connected component. 2 Press WIRELESS to switch the function to WIRELESS. When the sound is distorted 1 Move CHANNEL 1-3 on the transmitter to select a radio frequency. CHANNEL1: 913.5 MHz CHANNEL2: 914.0 MHz CHANNEL3: 914.5 MHz 2 Press WIRELESS. "AUTO TUNING" appears. If you do not hear clear audio, select another channel using CHANNEL1-3, then press WIRELESS again. To finish using WIRELESS function Press any function button to select different function and quit WIRELESS. Notes • You may not hear the beginning of the sound from the main unit until the transmitter starts sending the RF signals after detecting an audio signal. • If the transmitter is connected to the headphones jack of the source component, set the volume of that component as high as possible without distorting the audio signal. • If you hold the antenna of the transmitter with your hand, noise may occur. However this is not a malfunction. • When the transmitter is not to be used for a long period of time, disconnect the AC power adaptor from the wall outlet holding the plug. Do not pull on the cord. continued 11GB