Sony HCD-LF10 Operating Instructions - Page 32
Hanging the IR transmitter and IR receiver on a wall, To hang the IR receiver on a wall
View all Sony HCD-LF10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Hanging the IR transmitter and IR receiver on a wall You can hang the IR transmitter and IR receiver on a wall when: - there is an obstruction between the IR transmitter and the IR receiver. - people often pass between the IR transmitter and the IR receiver. When hanging both the IR transmitter and IR receiver, adjust the position of the IR transmitter after deciding the position of the IR receiver. To hang the IR receiver on a wall 3 Detach the IR receiver stand and hang 1 Prepare a screw (not supplied) that is suitable for the hole on the back of the IR receiver. See the illustrations below. it via hole on the rear side of the IR receiver on the screw. Make sure that the IR receiver does not move after installation. more than 20 mm (13/16 inch) 3 mm (1/8 inch) Hole on the back of the IR receiver 3.5 mm (5/32 inch) 3.5 mm (5/32 inch) IR receiver 8 mm (11/32 inch) 8 mm (11/32 inch) Hole on the back of the IR receiver 2 Fasten the screw to the wall. The screw should protrude 4 mm (3/16 inch). IR receiver stand Tip When reattaching the IR receiver stand to the IR receiver, attach the stand so that both delta marks on the IR receiver and stand are aligned (page 16). 4 mm (3/16 inch) 32GB