Sony HMZ-T1 Reference Guide - Page 28

HDMI Control Symptom Connected equipment cannot be controlled using the buttons on the head mounted unit Cause/Action p Make sure the connected equipment supports the HDMI CEC functions. p Make sure "Control for HDMI" setting of the connected equipment is configured correctly. For details, refer to the instruction manual of the equipment used. p The connected AV amplifier (receiver) may not be compatible with the system's "Control for HDMI" function. "Control for HDMI" function will not work correctly in this case. p Controlling connected equipment by pressing buttons on the head mounted unit may not be possible immediately after turning the system on, or immediately after activating "Control for HDMI" in "General Setup." p Make sure the "Control for HDMI" setting in "General Setup" is set to "On" (page 22). Other Issues Symptom Cause/Action The power indicator keeps flashing in red p If the indicator flashes twice every 3 seconds, the head mounted unit or processor unit may be damaged. Contact your Sony dealer or local authorized Sony service center. p If the indicator flashes three times every 3 seconds, the processor unit has overheated. Wait until the unit cools off and flashing stops. Make sure not to cover or obstruct the ventilation openings of the processor unit for proper ventilation. p If the indicator flashes four times every 3 seconds for a minute, the head mounted unit has overheated. Wait until the unit cools off and flashing stops. p If the indicator flashes five times every 3 seconds for a minute, both the head mounted unit and processor unit have overheated. Wait until the units cool off and flashing stops. When the system is off, video and audio from the playback equipment is not played on a TV connected to the HDMI OUT jack p Confirm that the HDMI cables are fully connected. p Set "HDMI pass-through" in "General Setup" to "On" (page 22). p Switch the input source on the TV to this system. p Check the HDMI output settings on the playback equipment. "Control for HDMI" on a TV cannot be used to control the playback equipment even when the system's HDMI pass-through is used p Refer to the instruction manual supplied with your TV, and in the TV's "Control for HDMI" setting, specify this system as the controlling device. Head mounted unit buttons p Buttons on the head mounted unit do not function unless you are are unresponsive wearing it. 28