Sony KDL-40SL150 Online Reference Book (.pdf version) - Page 7

Getting Started Operating the TV Using Features Using the Menus Other Information Specifications Getting Started > Installing the TV > Preparation for a Wall-Mount Bracket Preparation for a Wall-Mount Bracket All models except the 52 inch (measured diagonally) model can be mounted to a wall using the Wall-Mount Bracket (not supplied) out of the box as packaged. If you are mounting the 52 inch model to a wall, remove the Table-Top Stand. For removing the Table-Top Stand, refer to the instructions attached to the TV. Prepare the TV for the Wall-Mount Bracket before making cable connections. Sony strongly recommends that you use the Wall-Mount Bracket model designed for your TV and that wall-mounting of your TV should be performed by a Sony dealer or licensed contractor. z For bracket installation, refer to the instruction guide provided by the Wall-Mount Bracket model for your TV. z Sufficient expertise is required in installing this TV, especially to determine the strength of the wall for withstanding the TV's weight. z Be sure to use the screws supplied with the Wall-Mount Bracket when attaching the mounting hooks to the TV set. The supplied M6 screws are designed so that they are 12 mm to 16 mm in length when measured from the attaching surface of the mounting hook. The diameter and length of the screws differ depending on the Wall-Mount Bracket model. Use of screws other than those supplied may result in internal damage to the TV set or cause it to fall, etc. z Be sure to store the unused screws and Table-Top Stand in a safe place until you are ready to attach the Table-Top Stand. Keep the screws away from small children. For details on how to use the Wall-Mount Bracket compatible with your model, visit www.sony.com/accessories Or call United States) 1-877-899-7669 (for Canada) 1-800-488-7669 (for Follow the simple steps below to remove the Table-Top Stand: 1) Unplug the AC power cord and disconnect all the cables from the TV. 2) Secure the Mounting Hook to the rear of the TV. 3) Adjust the angle of the Mounting Hook. 4) Remove the screws on the rear of the TV (see illustration). Do not remove any other screws from the TV. 5) When screws are removed, lift the TV off the stand. Make sure that you carry out this task with at least two or three people. Do not attempt to lift the TV by yourself. Back to Preparation for a Table-Top Stand Next to Installing the Wall-Mount Bracket Home | Getting Started | Operating the TV | Using Features | Using the Menus | Other Information | Specifications Copyright © 2009 Sony Electronics Inc. All rights reserved.