Sony KV-27SXR10 Operating Instructions - Page 21
Specifications, Troubleshooting
View all Sony KV-27SXR10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Specifications Troubleshooting Television system American TV standard Channel coverage VHF: 2-13 UHF: 14-69 Cable TV: 1-125 Picture tube Microblack Trinitron tube 27SXR: 27-inch picture measured diagonally 28-inch picture tube measured diagonally 32SXR: 32-inch picture measured diagonally 34-inch picture tube measured diagonally Input VIDEO INPUT 1, 2 and 3 (phono jacks) Video: 1 Vp-p, 75-ohms unbalanced, sync negative Audio: 500 mVrms (100% modulation) Impedance: 47 kilohms S VIDEO INPUT (4-pin mini DIN) Y: 1 Vp-p, 75-ohms unbalanced, sync negative C: 0.286 Vp-p (Burst signal) 75-ohms Output MONITOR OUTPUT (phono jacks) Video: 1 Vp-p, 75-ohms unbalanced, sync negative Audio: 500 mVrms (100% modulation) Impedance: 10 kilohms AUDIO OUTPUT (VARIABLE) (phono jacks) - More than 408 mVrms at the maximum volume setting (variable) (100% modulation) Impedance: 10 kilohms Power requirements 120 V AC, 60 Hz Power consumption 27SXR: 170W (max.) 32SXR: 185W (max.) 1W (in standby condition) Accessories supplied Remote Commander RM-755 with 2 size AA batteries Antenna connector Optional accessories U/V mixer EAC-66 Connecting cord VMC-810S/820S RK-74A Design and specifications subject to change without notice. Disturbances in picture and sound can often be eliminated by checking the symptoms and following the suggestions listed below. GENERAL SYMPTOM Poor or no picture (screen not lit), good sound Good picture, no sound No picture (screen not lit), no sound No color Snow and noise only _ CHECK AND ADJUST • Adjust PICTURE. • Adjust BRIGHT. • Check antenna/cable connections. • Press VOLUME +. • Release MUTING on the Remote Commander. • Check that the MTS button is set correctly. • Check that the TV/VIDEO button or mode select button is set correctly. • Set the SPEAKER switch to ON. • Is POWER switched on? Power in outlet? • Check that the TV/ VIDEO button is set correctly. • Is it a color program? • Adjust COLOR. • Is it an active or the correct channel? • Check the CABLE selector setting. • Check antenna/cable connections. • Check that the ANT/AUX button is set correctly. ....,s,.• - .:.,4:.. .. -i Dotted lines 74.-•---t,-.'-,.v-a-.J' '.-.z...1, or stripes This is often caused by local interference. (e.g. cars, neon signs, hairdryers etc.) Adjust antenna for minimum interference. Reflections from nearby --, Double mountains or buildings images often cause this problem. or A highly directional • ' ghOsts outdoor antenna or a CATV I - cable may improve the picture. Try another channel. It could be station trouble. Program start TIMER and/or channel BLOCK does not operate properly. • Is the clock set correctly? • Is the setting correct? • Have you unplugged the unit? Has a power failure occurred? If so, the settings have been erased. TIMER/BLOCK If the problem persists, contact your nearest service facility. 22