Sony KV-27SXR10 Operating Instructions - Page 9

Operation Seeing TV program 1-er 4 6 3 1 MUTING button JUMP button SLEEP lamp 5 C:3 0 c:3 O c] 0 ci al 1:3 6 ca t=1 mr, 0 CO 0 I 010 0 0 0 2 Ci=1 O0 0 C=1TO 0 0 0 0 0 0 00 O 0 ao o o o 0 0001 5 , 6 1 Press POWER to turn on the TV. 2 If the "VIDEO 1", "VIDEO 2", "VIDEO 3", or "EXT-A" indication is displayed on the screen, press the TV button on the Remote Commander so that a channel number is displayed. 3 Set the CABLE selector For VHF and UHF channels : OFF For cable TV programs : ON 4 Press the ANT/AUX button as necessary. For VHF, UHF and regular cable TV channels: the "AUX" indication should be off. For pay cable TV channels: the indication should be displayed. 5 Select channels in one of the following two ways. • Press the numeral(s) of the channel, then press ENTER. Example: To select channel 6, press 6 and ENTER. To select channel 125, press 1, 2, 5 and ENTER. If you pressed a wrong numeral, wait for a few seconds until it disappears. Then, try again. • Press CH or CHANNEL "+" for higher-numbered charine1s and "-" for lower-numbered channels. 6 Press VOL or VOLUME "+" or "-" to adjust the volume and PICTURE "+" or "-" to adjust the picture. To switch quickly between 2 channels, press JUMP. Each time JUMP is pressed, the channel which appeared on the screen directly before is recalled. This button enables you to keep track of two programs alternately. To mute the sound, press MUTING. The "MUTING" indication will appear on the screen. To restore the sound, press MUTING again or VOL +/-. To turn off the unit, press POWER again. To have the TV turn off automatically after 1 hour, press SLEEP. The "SLEEP" indication will appear on the screen for a few seconds and the SLEEP lamp on the TV will remain lit until the TV is turned off. To cancel the SLEEP timer, press SLEEP again so that the SLEEP lamp goes out, or turn off the TV. 9