Sony KZ-32TS1/US Operating Instructions primary manual - Page 10
Connecting a Satellite Receiver with a VCR
View all Sony KZ-32TS1/US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installing and Connecting the TV Connecting a Satellite Receiver with a VCR Disconnect all power sources before making any connections. 1 Connect the satellite antenna cable to the satellite receiver's SATELLITE IN jack. 2 Connect the CATV cable to the VCR's VHF/UHF IN jack. 3 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack to the TV's VHF/UHF jack. 4 Using AUDIO and S VIDEO cables, connect the satellite receiver's AUDIO and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO IN jacks. 5 Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks. Rear of TV VIDEO IN 1 R AUDIO L VIDEO S VIDEO VIDEO IN 2 COMPONENT VIDEO IN 1 AUDIO OUT R AUDIO L Y PB PR R L R AUDIO L Y/G PB/B PR/R HD CONTROL S IN VD OUT COMPONENT VIDEO IN 2 / RGB IN SUB WOOFER VHF/UHF AC IN AUDIO-R (red) AUDIO-L (white) VIDEO (yellow) S VIDEO 75-ohm coaxial cable (supplied) Satellite antenna Satellite receiver cable YC-15V/30V (not supplied) VCR VMC810S/820S (not supplied) VMC-810S/820S (not supplied) YC-15V/30V (not supplied) Cable Tips • Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for instructions. • Use VIDEO on the remote to select VIDEO IN 1 to watch satellite TV or the VCR (your VCR must be turned on). Use 0-9 and ENTER or CH +/- on the remote to watch cable TV. • If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. 10 (US)