Sony MDS-JB940 Operating Instructions - Page 19
Marking track numbers while recording, (Track Marking), Track, Marking - manual
![]() |
View all Sony MDS-JB940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Recording to MDs To stop Input Monitor Press x. Erasing blank portions automatically (Smart Space/Auto Cut) The deck can be set to automatically erase any blanks that are produced when the signal is interrupted during recording. The function that activates (Smart Space or Auto Cut) depends on the length of the interruption, as described below. Smart Space If the signal is interrupted for less than 30 seconds, Smart Space replaces the blank portion with a blank space of about three seconds, then continues the recording. "Smart Space" appears in the display during this time. Auto Cut If the signal is interrupted for about 30 seconds, Auto Cut replaces the blank portion with a blank space of about three seconds, then pauses the recording. "Auto Cut" appears in the display during this time. Do the procedure below to turn Smart Space and Auto Cut on or off. 1 While the deck is stopped, press MENU/NO twice. "Setup Menu" appears in the display. 2 Turn AMS (or press ./> repeatedly) until "S.Space On" appears, then press AMS or YES. 3 Turn AMS (or press ./> repeatedly) to select the setting, then press AMS or YES. To Turn on Smart Space and Auto Cut Turn off Smart Space and Auto Cut Select S.Space On (factory setting) S.Space Off 4 Press MENU/NO. Notes • If you start recording with no signal input, Smart Space and Auto Cut will not operate regardless of the setting. • Smart Space does not affect the order of the track numbers being recorded, even if the blank space occurs in the middle of a track. • Auto Cut is automatically turned on or off in tandem with Smart Space. • If you turn off the deck or disconnect the AC power cord, the deck will store the last setting ("S.Space On" or "S.Space Off") and recall it the next time you turn on the deck. • If the deck continues recording pause for about 10 minutes after the Auto Cut activated, recording stops automatically. Marking track numbers while recording (Track Marking) You can mark track numbers either manually or automatically while recording. By marking track numbers at specific points, you can quickly locate the points later or edit the MD easily. RC z MNNO S AMS Marking track numbers manually (Manual Track Marking) While recording, press REC z at the point where you want to add a track number. Marking track numbers automatically (Automatic Track Marking) When recording from a CD player or MD deck connected to a DIGITAL IN connector, the deck marks track numbers in the same sequence as the source. When recording from other sources connected to the DIGITAL IN connector or a source connected to the ANALOG IN jacks, do the procedure below to mark track numbers automatically. However, you cannot mark track numbers automatically if the sound source to be recorded is noisy (e.g., tapes or radio programs). 1 While the deck is stopped, press MENU/NO twice. "Setup Menu" appears in the display. 2 Turn AMS (or press ./> repeatedly) until "T.Mark Lsyn" appears, then press AMS or YES. 3 Turn AMS (or press ./> repeatedly) to select the setting, then press AMS or YES. To Turn on Automatic Track Marking Turn off Automatic Track Marking Select T.Mark Lsyn (factory setting) T.Mark Off 19 Recording tips/Marking track numbers while recording GB
![](/manual_guide/products/sony-mdsjb940-operating-instructions-8052362/19.png)