Sony MHC-DP700 Operating Instructions - Page 10
Specifying the speaker parameters, Adjustable parameters, BALANCE, LEVEL MHC-DP800AV only, D.COMP.
View all Sony MHC-DP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Specifying the speaker parameters Use the remote for the operation. 1 From your listening position, press SPEAKER LEVEL. Adjustable menus and parameters are described below. 2 Press v or V repeatedly to select the parameter. 3 Press b or B repeatedly to select the setting you want. 4 Repeat steps 2 to 3 to set other parameters. 5 Press ENTER. Tip You can use the digipad instead of the cursor buttons (v/V/b/B). Adjustable parameters The default settings are in the parentheses. x BALANCE • FRNT L___R: (center) Balance between the front left and right speakers. • (MHC-DP800AV only) REAR L___R: (center) Balance between the rear left and right speakers. Range: 6 dB (L) to 6 dB (R), 13 steps x LEVEL (MHC-DP800AV only) • REAR ** dB: (0 dB) Level of the rear speakers. Range: -6 dB to 6 dB, 1 dB steps • CTR ** dB: (0 dB) Level of the center speaker. Range: -6 dB to 6 dB, 1 dB steps • SW ** dB: (10 dB) Level of the sub woofer. Range: -10 dB to 10 dB, 1 dB steps x LFE • LFE *****: (0 dB) Level of the LFE (Low Frequency Effect) channel output. Range: OFF, -20 dB to 0 dB, 1 dB steps "OFF" cuts the sound of the LFE channel. However, the low frequency sound of the speakers are output from the sub woofer. "-20 dB" to "0 dB" settings allow you to attenuate the LFE signal. "0 dB" outputs the full LFE signal at the mix level determined by the recording engineer. x D.COMP. • D.COMP.: (STD) Dynamic range compression. Range: OFF, 0.1 to 0.9, STD, MAX "OFF" does not compress the dynamic range. "0.1" to "0.9" settings allow you to compress the dynamic range in small steps. "STD" reproduces the sound track with the dynamic range intended by the recording engineer. "MAX" provides a great compression of the dynamic range. x T.TONE (MHC-DP800AV only) • T.TONE: (OFF) Test tone output. Range: OFF, ON "ON" outputs the test tone from each speaker in sequence. Adjust the LEVEL and BALANCE parameters so that the volume level of the test tone from each speaker sounds the same using the remote from your listening position. Select "OFF" to turn off the test tone. Notes • When you adjust the level of the sub woofer, set T.TONE to "OFF". • Dynamic range compression is possible with Dolby Digital sources only. 10