Sony MHC-NX3AV Operating Instructions (primary manual) - Page 11
Saving the power in standby mode - manuale
View all Sony MHC-NX3AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
To tune in a station with a weak signal Press + or - repeatedly in step 2 to tune in the station manually. To set another station to the exist preset number Start over from step 1. After step 3, turn the jog dial to select the preset number you want to store the other station. You can add a new preset number after the last preset number. To erase a preset station 1 Keep pressing TUNER MEMORY until a preset number flashes in the display. TUNED STEREO Saving the power in standby mode (U.S.A., Canadian and European models only) You can lower the power consumption to a minimum (Power Saving Mode) and save energy in the standby mode. 1/u (Power) DISPLAY 2 Turn the jog dial to select the preset number you want to erase. Select "ALL ERASE" when you want to erase all the preset stations. 3 Press ENTER. "COMPLETE!!" appears. When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered. To change the AM tuning interval (Except for European and Middle Eastern models) The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the TUNER MEMORY, press 1/u to turn the power back on. When you change the interval, AM preset stations will be erased. To reset the interval, repeat the same procedure. Tip The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs. - + 0 ) ≠ + - + g POWER SAVE/DEMO (STANDBY) / Press POWER SAVE/DEMO (STANDBY) when the power is off. The system switches to the Power Saving Mode and the clock display disappears. The system is powering on/off by pressing 1/u. Tips • Each time you press POWER SAVE/DEMO (STANDBY) in the Power Saving Mode, the display switches between the Power Saving Mode and the demo mode. • 1/u indicator and timer indicator (when the timer is set) light up even in the Power Saving Mode. • The timer works in the Power Saving Mode. Notes • You cannot set the time in the Power Saving Mode. • One Touch Play function does not work in the Power Saving Mode. To cancel the Power Saving Mode Press DISPLAY. The clock display appears. 11