Sony SCD-XA9000ES Operating Instructions (primary manual) - Page 32

Display Messages Specifications The following table explains the various messages that appear in the display. Message Error code(s) Cause and/or remedy TOC ERROR - An incompatible disc is inserted. BUS FULL C78:15 The signal bus within the i.LINK configuration is full and no more signals can be output from the player. Cancel the LINC between the component and this player. When a super audio CD is played Playing frequency range 2 Hz to 100 kHz Frequency response 2 Hz to 50 kHz (-3 dB) Dynamic range 108 dB or more Total harmonic distortion rate 0.0012 % or less Wow and flutter Value of measurable limit (±0.001 % W. PEAK) or less When a CD is played Frequency response 2 Hz to 20 kHz Dynamic range 100 dB or more Total harmonic distortion rate 0.0017 % or less Wow and flutter Value of measurable limit (±0.001 % W. PEAK) or less Output connector Jack type Output level Load impedance ANALOG OUT Phono jacks 2 Vrms Over 10 kilohms (at 50 kilohms) DIGITAL (CD) OUT OPTICAL* Square -18 dBm optical output connector ( ) Light emitting wave length: 660 nm DIGITAL (CD) Coaxial 0.5 Vp-p OUT output COAXIAL* connector 75 ohms PHONES Stereo 10 mW phone jack 32 ohms *Output only the audio signals of the CD i.LINK section Pin 4 pins Transmission speed S200 (Maximum data transmission speed 200 Mbps) Transmission protocol A/M transmission protocol Format (output) Super Audio CD* (DSD PLAIN) 2 channel linear PCM (IEC 60958-3) Sampling frequency: 44.1 kHz * Conforms to the copy protection technology of DTLA (Revision 1.2). Additional Information 32US