Sony SDM-X75K Operating Instructions (English starts on page 25) - Page 35

If no picture appears on your screen • Check that the power cord and the video signal cables are properly connected. • If "NO INPUT SIGNAL" appears on the screen: - The computer is in the power saving mode. Try pressing any key on the keyboard or moving the mouse. - Check that the input signal setting is correct by pressing the OK button (page 11). • If "CABLE DISCONNECTED" appears on the screen: - Check that the video signal cables are properly connected. - Check that the input signal setting is correct by pressing the OK button (page 11). • If "OUT OF RANGE" appears on the screen: Reconnect the old display. Then adjust the computer's graphics board within the following ranges. Analog RGB Digital RGB Horizontal frequency 28-80 kHz 28-64 kHz Vertical frequency 48-75 Hz 60 Hz Resolution 1280 × 1024 or less For more information about the on-screen messages, see "Trouble symptoms and remedies" on page 19. No need for specific drivers The display complies with the "DDC" Plug & Play standard and automatically detects all the display's information. No specific driver needs to be installed to the computer. The first time you turn on your computer after connecting the display, the setup Wizard may appear on the screen. If this is the case, follow the onscreen instructions. The Plug & Play display is automatically selected so that you can use this display. The vertical frequency turns to 60 Hz. Since flickers are unobtrusive on the display, you can use it as is. You do not need to set the vertical frequency to any particular high value. Setup 8: Adjust the tilt and height This display can be adjusted within the angles shown below. Hold both sides of the LCD display, then adjust display angles. approx. 5° approx. 20° GB approx. 175° approx. 175° When you use the height adjustable stand, the height adjust is also available as below. Hold both sides of the LCD display, and then adjust the display height. approx. 110 mm (4 11/32 inches) 11