Sony SLV-N50 Operating Instructions - Page 6

Controlling other TVs with the remote commander The remote commander is preprogrammed to control non-Sony TVs. If your TV is listed in the following table, set the appropriate manufacturer's code number. 1 Set [TV] / [VIDEO] at the top of the remote commander to [TV]. 2 Hold down ?/1, and enter your TV's code number using the number buttons. Then release ?/1. Now you can use the ?/1, VOL +/-, CH +/-, and TV/VIDEO buttons to control your TV. You can also use the buttons marked with a dot (•) to control a Sony TV. To control the VCR, reset [TV] / [VIDEO] to [VIDEO]. Code numbers of controllable TVs If more than one code number is listed, try entering them one at a time until you find the one that works with your TV. TV brand Sony Akai AOC Centurion Coronado Curtis-Mathes Daytron Emerson Fisher General Electric Gold Star Hitachi J.C.Penney Code number 01 04 04 12 03 12 12 03, 04, 14 11 06, 10 03, 04, 17 02, 03 04, 12 TV brand Code number JVC 09 KMC 03 Magnavox 03, 08, 12 Marantz 04, 13 MGA/Mitsubishi 04, 12, 13, 17 NEC 04, 12 Panasonic 06, 19 Philco 03, 04 Philips 08 Pioneer 16 Portland 03 Quasar 06, 18 Radio Shack 05, 14 TV brand RCA Sampo Sanyo Scott Sears Sharp Sylvania Teknika Toshiba Wards Yorx Zenith Code number 04, 10 12 11 12 07, 10, 11 03, 05, 18 08, 12 03, 08, 14 07 03, 04, 12 12 15 Notes • If you enter a new code number, the code number previously entered will be erased. • If the TV uses a different remote control system from the one programmed to work with the VCR, you cannot control your TV with the remote commander. • When you replace the batteries of the remote commander, the code number may change. Set the appropriate code number every time you replace the batteries. • When you press the AUDIO MONITOR button, your TV's menu may appear on the TV screen. To exit the TV menu, press the MENU button on the TV remote commander or wait until the menu disappears automatically. 6 Setting up the remote commander