Sony SPP-A945 Operating Instructions - Page 13

Basics Making calls TALK lamp VOL switch (HOLD) (*TONE) (CHANNEL) 1 Press (TALK/FLASH). The TALK lamp lights up, then you will hear a dial tone. If you hear beeps, move closer to the base phone. 2 (REDIAL) Dial the phone number. 3 When you are done talking, press (OFF) or replace the handset on the base phone. The TALK lamp goes off. Basics Additional tasks To Do this Put a call on hold Press (HOLD). The TALK lamp flashes slowly. Press (TALK/FLASH) to resume the conversation. Improve reception Press (CHANNEL)*. Adjust the handset volume Slide the VOL switch. Switch to tone dialing temporarily Press (*TONE) after you are connected. The line will remain in tone dialing until disconnected. * If you hear a long beep when you press (CHANNEL), move closer to the base phone. Notes • Before dialing, make sure you can hear the dial tone. Otherwise you cannot dial correctly. • When the TALK lamp lights up by pressing (TALK/FLASH), the IN USE lamp on the base phone lights up simultaneously. • When the TALK lamp repeats sets of two flashes, the base phone is in use. If the handset battery becomes weak during a call You hear a beep and the BATT LOW lamp on the handset flashes. The call will disconnect soon. Replace the handset on the base phone to charge. continued Basics 13EN