Sony SRXT105 Installation Guide (SXRD-install) - Page 22

SMTP Authentication: Selects when "SMTP Authentication" is necessary when e-mail is sent. Account Name: Enter the user name to log in to the SMTP server. Password: Enter the password of the user to log in to the SMTP server. Send Test Mail: Check the check box if you want to send a test mail. PC Communication The PC Communication window is used to configure for communication between the projector and the computer for controlling the projector. Network Block Reboot Restarts the Network CPU after the PC Communication settings complete. Click the "REBOOT" button to restart. SNMP The window is used to set up SNMP (Simple Network Management Protocol). Chapter 2 Installation and Connections List box List box Projector Identifying Configures the projector. Port No.: Enter the UDP port number. Interval: Select the interval at which the IP packets are sent. Select from the drop-down list displayed by clicking . Broadcast Address: Enter the broadcast address. : Registers the entered IP address in the list. : Deletes the IP address from the list. List box: Displays the registered broadcast addresses. Controlling PC Destination Configures the computer for controlling the projector. Port No.: Enter the TCP port number. Time-out: Select the time when the communication is to end. Select from the drop-down list displayed by clicking . Accept connections from these hosts: Enter the IP address of a host who is allowed to access the projector. : Registers the entered IP address in the list. : Deletes the registered IP address from the list. List box: Displays the registered IP addresses of the hosts allowed to access the projector. SNMP sysName: Enter the characters for the standard MIB sysName. Contact: Enter the characters for the standard MIB sysContact. Location: Enter the characters for the standard MIB sysDescr. Send authentication trap: Selects when you permit sending authentication trap. Accept SNMP packets from any host: Selects when you permit access to the projector from any host. Accept SNMP packets from these hosts: Selects when access to the projector is allowed for specified hosts only. Enter the IP address of the host permitted to access the projector in the text box. : Register the entered IP address in the list. : Deletes the registered IP address from the list. List box: Displays the registered IP addresses of the hosts allowed to access. Community: Selects and edit the community name. "Add" button: Click to add the selected community name. "Edit" button: Click to enter edit mode for attributes of the selected community. "Remove" button: Click to remove the selected community. Community Name: Clicking the "Edit" button displays the community name whose attributes can be edited, and the following items are activated: Rights: Selects the access right. "Set to List" button: Click to apply the change of attributes. 22 Setting the Projector