Sony SRXT105 Installation Guide (SXRD-install) - Page 26
Signal Info (Information), Signal Adjust, I/P Mode, Contrast, Brightness, Color, Sharpness
View all Sony SRXT105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 3 Adjustments and Settings Using the SRX Controller compliance, or "10bit Twin Limited" or "10bit Single Limited" for a signal of Limited Range compliance. When the LKRI-001 is installed Select "YPbPr" to input a high-definition signal from component equipment, and "RGB" to input a highdefinition signal from video GBR equipment. When the LKRI-003 is installed For Single-link input, select "YPbPr" or "YPbPr FULL". For Dual-link input, select "RGB" or "RGB FULL". When "RGB" or "YPbPr" is selected, in the case that a 10-bit HD-SDI signal is input and "Contrast" is set to 90 in "Signal Adjust" of the PICTURE CONTROL window, mapping is done so that HD-SDI signal data values 1) of 64 to 960 are converted to the video levels of 0 to 100% to display an image on the projector. When "RGB FULL" or "YPbPr FULL" is selected, in the case that a 10-bit HD-SDI signal is input and "Contrast" is set to 90 in "Signal Adjust" of the PICTURE CONTROL window, mapping is done so that HD-SDI signal data values of 0 to 1023 are converted to the video levels of 0 to 100% to display an image on the projector. In this case, inhibition codes included in a 10-bit HD-SDI signal (data area 0 to 3, and 1020 to 1023) are blocked out. 1) Data value 64 of a 10-bit HD-SDI signal input is equivalent to the video level of 0% (black), and data value 960 equivalent to 100% (white). I/P Mode: Selects the I/P conversion mode. Depending on the input signal source, set the mode to "Interlace" or "PsF". Clicking the "RESET" button resets the following four settings to the factory preset values. Contrast: Adjusts the picture contrast. The higher the setting, the greater the contrast. Brightness: Adjusts the picture brightness. The higher the setting, the brighter the picture. Color: Adjusts the color intensity. The higher the setting, the greater the intensity. Sharpness: Adjusts the picture sharpness. The higher the setting, the sharper the picture. The lower the setting, the softer the picture. Notes • This item is available with the interlace or PsF signal input. • When the LKRI-004 or LKRI-005 is installed, this item is not available. Signal Info (Information) Shows the horizontal and vertical frequencies of the input signal automatically. The values are approximate. The type of the input signal is also displayed. fH: Displays the horizontal frequency. fV: Displays the vertical frequency. Signal Adjust Adjusts the picture quality of the input signal. Clicking increases the setting value, and decreases it. 26 PICTURE CONTROL Window