Sony SRXT105 Installation Guide (SXRD-install) - Page 25

About the items that cannot be adjusted Items that cannot be adjusted depending on the input signal are not displayed in the window. For details, see "Input Signals And Adjustable/Setting Items" on page 34. Log function Clicking the "Save Log" in the "File" menu on the menu bar in the Control Function Menu window saves the communication log between the T100 Controller and this projector up to the moment "Save Log" is clicked. Up to 5 MB can be saved. PICTURE CONTROL Window The PICTURE CONTROL window is used to select the input source or to adjust the picture quality. When the screen mode is set to dual-screen mode or quadscreen mode, the items can be independently adjusted for each input channel displayed on the screen. Chapter 3 Adjustments and Settings Using the SRX Controller Board Shows the input board installed in the relative input board slot of the projector. Input Source Signal Mode: Click to open the drop-down list to select the type of signal input from equipment connected to the optional input board. When the LKRI-004 or LKRI-005 is installed Select the input signal type of progressive DVI-D signals. When used in normal, select "8bit Single Full", which is compatible with DVI1.0 standard and the signal level is Full Range compliance. When the DTV signal is input, select "8bit Single Limited", which is compatible with DVI1.0 standard and the signal level is Limited Range compliance. When the 10-bit signal based on Sony's unique specification is input, select "10bit Twin Full" or "10bit Single Full" for a signal of Full Range 25 PICTURE CONTROL Window