Sony STR-DA2800ES Operating Instructions - Page 129
Universal Remote Control, Lighting Control, The Universal Remote Control function
View all Sony STR-DA2800ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Additional Information • Make sure that the command modes of the receiver and the remote control are the same. If the command mode of the receiver and the remote control are different, you cannot operate the receiver with the remote control (page 87). • Make sure you select the correct input on the remote control. If the trouble is other than one of the cases described above and the trouble is not solved even if you wait for a while, perform either of the operations below. • Press ?/1 on the remote control to turn the receiver off and then on again. • Hold down ?/1 on the receiver until the lamp above the button flashes in green to reboot the receiver. Universal Remote Control The Universal Remote Control function does not work. • Make sure the connections required are made. If the trouble is other than one of the cases described above and the trouble is not solved even if you wait for a while, perform either of the operations below. • Press ?/1 on the remote control to turn the receiver off and then on again. • Hold down ?/1 on the receiver until the lamp above the button flashes in green to reboot the receiver. • If the remote sensor of the receiver and that of another Sony product face the same direction, interference may occur. In this case, set the remote sensors so that they face different directions or use an IR shield on the other Sony product to shield the IR from interference from the receiver IR remote. • Make sure the receiver is connected to the Internet. • Press ROOM OFF on the remote control to turn off the receiver and the AV equipment. Lighting Control The lighting device cannot be identified. • Try pressing the button on the top of the lighting device 4 times. Then repeat this procedure more than once. • If the LED continues blinking weakly, press and hold the button on the lighting device for 5 seconds then tap four times on the button on the wizard. • To reset the lighting device, press the button on the top of the lighting device 13 times. the LED will turn to red and then back to green or emit an orange-yellow strobe. The lighting device cannot be operated. • The device may be updating its software. Wait for about half an hour until the update is completed. • It may be off-line. Wait for half an hour until the device returns online. • Reset the lighting device and delete the identified device on the receiver. Reboot the receiver and then set up the Lighting Control function again. Also perform the procedures necessary to reset the lighting device described above. The Lighting Control function doesn't work. • The Lighting Control Adapter may have been unplugged while the power was on and the system data may be corrupted. Reset the lighting device and delete the identified devices on the receiver. Then reboot the receiver and set up the Lighting Control function again. • Hold down ?/1 on the receiver until the lamp above ?/1 flashes in green to reboot the receiver. 129US