Sony STR-DA3600ES Operating Instructions (Large File - 16.4 MB) - Page 137

For Installation Purposes: Operating Each Component Using an External Control Device (Quick Click) 5 Select "Learn Mode," then press . 6 Select the code number you want to store as the new command, then press . 7 Keep pressing the corresponding button on the remote of the component to be programmed while pointing the remote toward the receiver's remote sensor until "Complete" is displayed on the TV screen. Remote sensor About 5 cm - 10 cm (2" - 4") "Test" is selected automatically after few seconds when the registration of a new code is completed. 8 Press . The operation test of the programmed code is started. Proceed to step 9 if you will not perform the operation test. 9 Select "Finish," then press . Note The display window is turned off while the receiver is registering the new code. Resetting the remote code for Quick Click V/v/b, MENU 1 Select " Settings" from the menu, then press or b. 2 Select "Quick Click," then press . 3 Select "Source Component," or "Common Component," then press . 4 Select the component you want, then press . 5 Select "Reset," then press . The confirming message appears on the TV screen. 6 Select "Yes," then press . All the contents of the selected input (e.g., all the programmed data) are cleared. 7 Repeat steps 4 to 6 to clear all programmed data. Note The macro itself is not cleared. A default code will be output when you have set a preset code or learned code in the macro step. 137GB