Sony STR-DH510 Operating Instructions - Page 75
Specifications, AUDIO POWER - troubleshoot
UPC - 027242780002
View all Sony STR-DH510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
If you are unable to remedy the problem using the troubleshooting guide Clearing the receiver's memory may remedy the problem (page 30). However, note that all memorized settings will be reset to their initial settings and you will have to readjust all settings on the receiver. If the problem persist Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained. Reference sections for clearing the receiver's memory To clear All memorized settings Customized sound fields See page 30 page 46 Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U2 only) With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 90 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Models of area code U21) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 90 W + 90 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%) 100 W + 100 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 130 W per channel Models of area code CA2, ECE, CEK, AU11) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 85 W + 85 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%) 100 W + 100 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 130 W per channel 1)Measured under the following conditions: Area code Power requirements U2, CA2 120 V AC, 60 Hz ECE, CEK, AU1 230 V AC, 50 Hz 2)Reference power output for front, center and surround speakers. Depending on the sound field settings and the source, there may be no sound output. Additional Information continued 75GB