Sony STR-DN1010 Operating Instructions - Page 127
Tuner, HP NO LINK and VOL MIN appear
UPC - 027242779945
View all Sony STR-DN1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
No sound is heard from the S-AIR product. • If you use another S-AIR main unit, place it more than 26 feet (8 meters) away from this S-AIR main unit. • Confirm the ID of the S-AIR main unit and S-AIR sub unit are the same (page 77). • Confirm the pairing setting (page 78). • Place the S-AIR main unit and S-AIR sub unit closer to each other. • Avoid using the equipment that generates electromagnetic energy, such as a microwave oven. • Place the S-AIR main unit and S-AIR sub unit separately from other wireless devices. • Avoid using any other wireless devices. • Change the "RF Change" setting (page 81). • Change the ID settings of the S-AIR main unit and S-AIR sub unit. • Turn off the system and S-AIR sub unit, then turn them on again. • Check that headphones are not connected to the S-AIR sub unit. There is noise or the sound skips. • If you use another S-AIR main unit, place it more than 26 feet (8 meters) away from this S-AIR main unit. • Sources with copyright protection may not be playable on S-AIR sub unit. • Place the S-AIR main unit and S-AIR sub unit closer to each other. • Avoid using the equipment that generates electromagnetic energy, such as a microwave oven. • Place the S-AIR main unit and S-AIR sub unit separately from other wireless devices. • Avoid using any other wireless devices. • Change the "RF Change" setting (page 81). • Change the ID settings of the S-AIR main unit and S-AIR sub unit. "HP NO LINK" and "VOL MIN" appear alternately on the display and the volume of the receiver becomes minimum. • Volume becomes minimum when you turn off the surround amplifier with headphones connected or if the radio reception is poor. In these cases, check the radio reception and adjust the volume level to restore sound from the headphones. Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antennas (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe. Outdoor FM antenna (aerial) Receiver Ground wire (not supplied) To ground Additional Information continued 127GB