Sony UP-DP10 Operating Instructions / Mode d’emploi - Page 8
Connecting the Power Supply, Turning the Power On/Off, When connecting to a printer port
View all Sony UP-DP10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Setup and Connection When connecting to a printer port Printer cable (purchased separately) To printer port Turning the Power On/Off Press the Operation switch so that the POWER lamp is on. To turn the printer off, press the Operation switch again. To parallel port (Amphenol 36-pin connector) Windows 95/98 computer Note When using the printer in fast transfer mode (ECP mode), use an IEEE1284-compliant cable. Note that in order to use fast transfer mode, the parallel port must be set up on the personal computer side. For details, refer to the operating manual for the personal computer. Connecting the Power Supply Plug the female end of the power cord into the AC power inlet on the printer, and then plug the other end into an AC power outlet. Plug To outlet 8