Sony VPL EX7 Operating Instructions - Page 18

Connecting the Projector, Connecting a Computer - vpl ex70 manual

Page 18 highlights

Connecting the Projector When you connect the projector, make sure to: • Turn off all equipment before making any connections. • Use the proper cables for each connection. • Insert the cable plugs firmly; loose connections may increase noise and reduce performance of picture signals. When pulling out a cable, be sure to pull it out by the plug, not the cable itself. Connecting a Computer This section describes how to connect the projector to a computer. For more information, refer to the computer's instruction manual. To connect a computer Rear side VPL-EX70 to monitor output Computer to audio input 18 Connecting the Projector 1 HD D-sub 15-pin cable (supplied) 2 Stereo audio connecting cable (not supplied) (Use a no-resistance cable.) Notes • For stereo audio connection, connect the stereo audio connecting cable to the AUDIO INPUT connector. • The projector accepts VGA, SVGA, XGA, SXGA, SXGA+, WXGA signals. However, we recommend that you set the output mode of your computer to SVGA (VPL-ES7) or XGA (VPL-EX70/EX7) mode for the external monitor. • If you set your computer, such as a notebook computer, to output the signal to both your computer's display and the external monitor, the picture of the external monitor may not

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60

18
Connecting the Projector
Connecting the
Projector
When you connect the projector,
make sure to:
Turn off all equipment before making any
connections.
Use the proper cables for each connection.
Insert the cable plugs firmly; loose
connections may increase noise and
reduce performance of picture signals.
When pulling out a cable, be sure to pull it
out by the plug, not the cable itself.
This section describes how to connect the
projector to a computer.
For more information, refer to the
computer’s instruction manual.
To connect a computer
1
HD D-sub 15-pin cable (supplied)
2
Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
For stereo audio connection, connect the
stereo audio connecting cable to the AUDIO
INPUT connector.
The projector accepts VGA, SVGA, XGA,
SXGA, SXGA+, WXGA signals. However,
we recommend that you set the output mode
of your computer to SVGA (VPL-ES7) or
XGA (VPL-EX70/EX7) mode for the
external monitor.
If you set your computer, such as a notebook
computer, to output the signal to both your
computer’s display and the external monitor,
the picture of the external monitor may not
Connecting a Computer
Notes
Rear side
to monitor output
Computer
VPL-EX70
to audio input