Sony VPL EX7 Operating Instructions - Page 19

Projecting the Picture appear properly. Set your computer to output the signal to only the external monitor. For details, refer to the operating instructions supplied with your computer. Note To connect a Macintosh computer equipped with a video output connector of a type having two rows of pins, use a commercially available plug adaptor. 1 Stereo audio connecting cable (not supplied) (Use a no-resistance cable.) 2 Video cable (not supplied) or S-Video cable (not supplied) To connect to a video GBR/ Component output connector Rear side VPL-EX70 Connecting a VCR This section describes how to connect the projector to a VCR. For more information, refer to the instruction manuals of the equipment you are connecting. To connect to a video or S video output connector Rear side VPL-EX70 to audio output (L) to audio output (R) to video GBR/ component output to video output to audio output (L) to S video output to audio output (R) VCR VCR 1 Signal Cable (not supplied) HD D-sub 15-pin (male) ↔ 3 × phono jack 2 Stereo audio connecting cable (not supplied) (Use a no-resistance cable.) Notes • For stereo audio connection, connect the stereo audio connecting cable to the AUDIO INPUT connector. • Set the aspect ratio using "Aspect" on the INPUT SETTING menu according to the input signal. • When you connect the projector to a video GBR output connector, select "Video GBR" or when you connect the projector to a component output connector, select "Component" with the "Input-A Signal Sel." setting on the SET SETTING menu. Connecting the Projector 19