Sony VPL-FHZ57 Operating Instructions - Page 35

Setting items With Static Signal Standby Mode*11 Quick Reboot Direct Power On Description Light Dimming*8 *9: If an image does not change for about 10 seconds, light output is gradually reduced (approximately 10% to 15%*10) from that set in the Light Output Mode. This setting provides a convenient way to reduce power consumption. In addition, the light automatically darkens slowly to approximately 5% of its light output if the selected time ("5 min.," "10 min.," "15 min.," "20 min.," or "Demo.") elapses with no change to input signal. While dimming the light, the message "Light Dimming" appears. If you select "Demo.," the image will start to darken about 40 seconds later. When any change in signal is detected, or an operation (remote control or control panel) is performed, normal brightness is restored. Off: The "With Static Signal" function is disabled. Standard/Low: When set to "Low," lowers power consumption in standby mode. Off/10 min./30 min.: After you turn off the power, the projector is in standby mode for a quick start within the specified time (10 minutes or 30 minutes). The ON/STANDBY indicator lights in orange when the projector is in standby mode. (page 49) On/Off: When set to "On," you can turn the power on without going to standby mode when the AC power cord is connected to a wall outlet. You can also unplug the AC power cord without going to standby mode when you turn off the projector. You may unplug the AC power cord without going to standby mode. Notes *1: Set the IP address of this unit manually after connecting to the network. If this unit is not connected to the network, the setting is not enabled. *2: When connecting via HDBaseT, only the 100BASE-TX can be used for connection. When using the LAN terminal of the main unit, you can connect with the 10BASE-T/100BASE-TX. *3: The IP addresses when using HDBaseT and when using the LAN terminal should be set respectively. • Setting the IP address when using a LAN via HDBaseT. Set "LAN Setting" to "via HDBaseT" in "HDBaseT Settings," then set the IP address in "Network Setting." • Setting the IP address when using the LAN terminal. Set "LAN Setting" to "LAN Port" in "HDBaseT Settings," then set the IP address in "Network Setting." *4: When connecting via HDBaseT, the connection is at 9,600 bps. When using the RS-232C terminal of the main unit, you can connect at 38,400 bps. *5: If the image input setting of the HDMI connection equipment is not correct, the brighter part becomes too bright and the darker part becomes too dark. *6: The image may not be adjusted properly depending on the type of input signal. In such a case, adjust it manually to suit to the connected equipment. *7: Select "Off" to avoid entering standby mode when there is no input signal. *8: A change in signal may not be detected depending on the input image. If "With No Input" is set, it takes priority. *9: As the light is dimmed gradually, you may not notice any change in brightness. *10:This varies depending on the "Light Output Mode" setting (page 25). *11:When "Standby Mode" is set to "Low," the network and network control function cannot be operated while the projector is in standby mode. 35