Stihl BGA 60 Instruction Manual - Page 19
Mounting the Charger on a Wall
View all Stihl BGA 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
0000-GXX-0637-A0 0000-GXX-0609-A0 11 Charging the Battery the charger dry. Protect it from rain, water, liquids and damp conditions. Never insert a wet battery. Never use a wet charger, @ 11.2. To charge the battery: 3 2 4 1 ► Push the battery (2) into the charger (3) until it stops. The LED on the charger (4) glows green when the battery is charging. The LEDs (1) on the battery glow green and show the state of charge. When the LEDs on the battery turn off, the charging process is complete and the charger will shut itself off. The battery can be removed from the charger. ► Disconnect the power supply cord from the electrical outlet when the charger is not in use for extended periods of time. A battery is not fully charged when it ships from the factory. STIHL recommends that you fully charge the battery before using it the first time. Operate the charger only indoors, in dry rooms and within an ambient temperature range of 41 °F to 104 °F (5 °C to 40 °C). The battery heats up during operation of the blower. If a hot battery is inserted into the charger, it may be necessary for it to cool down before charging starts. The charging process begins only after the battery has cooled down sufficiently. English Charging time depends on a number of factors, including battery condition and the ambient temperature. For a complete list of approximate charging times, see www.stihl.com/charging-times. 11.3 Mounting the Charger on a Wall Before mounting, ensure that no electrical cables, pipes or other service lines run in the wall behind the charger. To mount the wall charger: 1 b2 3 c a ed f f ► Mount the charger indoors in a dry room near an electrical outlet. ► Sink the screws into a wall stud. Use appropriate screw-in wall anchors or other similar mounting devices if an appropriate wall stud is not available. ► Align the charger as shown above. Mount to a wall with the following dimensions: - a = minimum 18 in. (450 mm) - b = minimum 3.9 in. (100 mm) - c (for AL 101) = 3.0 in. (75 mm) - c (for AL 300 and AL 500) = 4.7 in. (120 mm) - d = 0.2 in. (4.5 mm) - e = 0.4 in. (9 mm) - f = 0.1 in. (2.5 mm) 0458-008-8601-A 17