Stihl FC Attachment Instruction Manual - Page 12

English Adjust correctly operator. This ensures that cuttings and other debris are directed away from the power tool and operator. Edging 239BA014 KN 3 B N Tighten down the wingnut clockwise. N Standing in the normal working 2 position, check the depth of cut again and correct it if necessary. 239BA013 KN 239BA016 KN The depth of cut depends on the unevenness of the ground, your height and the way you hold the edger. Use the following procedure: N Adjust the depth wheel (2) so that the blade (3) just touches the ground or breaks the surface of the soil by no more than 5 mm (B) WARNING Do not adjust the deflector. The deflector has been set at the factory so that the arrow on the deflector and the open side point away from the 239BA015 KN N Start the engine N Start the cut at no less than half throttle and continue cutting at full throttle. N Hold and guide your power tool so that the blade is vertical. N Cut steadily so that the engine is not lugged down - do not apply force. N Operate at no more than a normal walking pace. N Do not push the blade into the ground. 10 FCB-KM