Stihl FC Attachment Instruction Manual - Page 7
The Use Of The Power Tool
View all Stihl FC Attachment manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
THE POWER TOOL (KOMBIENGINE EQUIPPED WITH EDGER KOMBITOOL) For illustrations and definitions of the power tool parts see the chapter on "Main Parts." WARNING Never modify this power tool in any way. Only attachments supplied by STIHL and expressly approved by STIHL for use with the specific STIHL KombiEngine are authorized. Although certain unauthorized attachments are useable with STIHL power tools, their use may, in fact, be extremely dangerous. If this tool is subjected to unusually high loads for which it was not designed (e.g. heavy impact or a fall), always check that it is in good condition before continuing work. Check in particular that the controls and safety devices are working properly. Do not continue operating this machine if it is damaged. In case of doubt, have it checked by your STIHL servicing dealer. THE USE OF THE POWER TOOL (KOMBIENGINE EQUIPPED WITH EDGER KOMBITOOL) Transporting the Power Tool WARNING To reduce the risk of injury from loss of control and blade contact, never carry or transport your power tool with the cutting attachment moving. WARNING Always switch off the engine and make sure the cutting blade has stopped before putting a power tool down. It may be carried only in a horizontal position. Grip the shaft in a manner that the machine is balanced horizontally. Keep the hot muffler away from your body and the cutting attachment behind you. WARNING When transporting it in a vehicle, properly secure it to prevent turnover, fuel spillage and damage to the unit. Before Starting WARNING Always check your power tool for proper condition and operation before starting. Never attempt to modify the controls or safety devices. WARNING Never operate your power tool if it is damaged, improperly adjusted or maintained, or not completely or securely assembled. WARNING Do not attach any cutting attachment to a unit without proper installation of all required parts. Failure to use the proper parts may cause the blade to fly off and seriously injure the operator or bystanders. English WARNING The cutting attachment must be properly tightened and in safe operating condition. Inspect for loose parts (nuts, screws, etc.) and for cracked, bent, warped or damaged blades. Replace damaged blades before using the power tool. Keep the handles clean and dry at all times; it is particularly important to keep them free of moisture, pitch, oil, fuel mix, grease or resin in order for you to maintain a firm grip and properly control your power tool. WARNING To reduce the risk of personal injury to the operator from blade contact and thrown objects, make sure your unit is equipped with the proper deflector, handle and harness (if applicable). 239BA011 KN An arrow on the deflector shows the correct direction of rotation of the cutting blade. FCB-KM 5