Stihl FH Attachment Instruction Manual - Page 8

English Once the engine has started, immediately blip the throttle trigger, which should release the starting throttle and allow the engine to slow down to idle. With the engine running only at idle, attach the power tool to the spring hook of your harness (see appropriate chapter of this manual). WARNING Your power tool is a one-person machine. Do not allow other persons in the general work area, even when starting. See also the Safety Precautions on Starting in the instruction manual of your basic power tool. During Operation Holding and Controlling the Power Tool Always hold the unit firmly with both hands on the handles while you are working. Wrap your fingers and thumbs around the handles. Models with Bike Handle Right handle on control handle, left hand on left handle. 6 002BA055 KN Models with Loop Handle Your right hand should grip the control handle at the rear, and your left hand should grip the loop handle. This also applies to left-handers. WARNING Never attempt to operate your power tool with one hand. Loss of control of the power tool resulting in serious or fatal injury may result. To reduce the risk of cut injuries, keep hands and feet away from the cutting tool. Never touch a moving cutting tool with your hand or any other part of your body. WARNING Do not overreach. Keep proper footing and balance at all times. Special care must be taken in slippery conditions (wet ground, snow) and in difficult, overgrown terrain. Watch for hidden obstacles such as tree stumps, roots and ditches to avoid stumbling. For better footing, clear away fallen branches, scrub and cuttings. Be extremely cautious when working on slopes or uneven ground. 002BA080 KN WARNING To reduce the risk of injury from loss of control, never work on a ladder, in a tree or any other insecure support. Never hold the machine above shoulder height. Working Conditions Operate and start your power tool only outdoors in a well-ventilated area. Operate it under good visibility and daylight conditions only. Work carefully. WARNING If the vegetation being cut or the surrounding ground is coated with a chemical substance (such as an active pesticide or herbicide), read and follow the instructions and warnings that accompanied the substance at issue. WARNING Inhalation of certain dusts, especially organic dusts such as mold or pollen, can cause susceptible persons to have an allergic or asthmatic reaction. Substantial or repeated inhalation of dust and other airborne contaminants, in particular those with a smaller particle size, may cause respiratory or other illnesses. Control dust at the source where possible. Use good work practices, such as operating the unit so that the wind or operating process directs any dust raised by the power tool away from the operator. Follow the recommendations of EPA / OSHA / NIOSH and occupational and trade FH