Stihl FS 120 Product Instruction Manual - Page 29
Blocking the Output Shaft, Mounting the mowing head
View all Stihl FS 120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
002BA166 KN 002BA081 KN 681BA026 KN English / USA The rider plate (4) is in the parts kit supplied with the machine. : Go to "Mounting the Mowing Head" 5 or "Mounting Metal Cutting Tools". Blocking the Output Shaft 2 1 8 7 7 4 3 1 2 : Insert the stop pin or screwdriver (7) (supplied with machine or available as special accessories) in the hole (8) in the gearhead as far as stop - apply slight pressure. : Rotate nut or cutting tool on the shaft (2) until the stop pin slips into position and blocks the shaft. Mounting the mowing head Keep instruction sheet for mowing head in a safe place : Screw the STIHL SuperCut 20-2, STIHL AutoCut 25-2, 30-2 STIHL TrimCut 30-2 or STIHL PolyCut 20-3 counterclockwise onto the shaft (1) as far as stop. : Block the output shaft. : Tighten down the mowing head. Remove the stop pin. STIHL FixCut 25-2 : Place the mowing head on the thrust plate (2) Collar (see arrow) must locate in mowing head's mounting hole Push the thrust washer (3) over the shaft (1) so that it locates against the base. : Block the output shaft. : Screw the mounting nut (4) with the combination wrench (5) counterclockwise on to the output shaft and tighten down firmly Remove the stop pin. 28 FS 120, FS 120 R, FS 200, FS 200 R, FS 250, FS 250 R