Stihl MS 341 Instruction Manual - Page 46
Standard Setting, Adjusting Idle Speed
View all Stihl MS 341 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
English / USA 213BA013 KN 213BA014 KN 213BA015 KN Standard Setting HL H L Adjusting Idle Speed L L Erratic idling behavior, poor acceleration (although L screw is open 1/4 turn) HL H L : Shut off the engine. : Check the air filter and clean or replace if necessary. : Check the spark arresting screen* in the muffler and clean or replace if necessary. : Turn the high speed screw (H) counterclockwise as far as stop (no more than 3/4 turn). : Turn the low speed screw (L) clockwise as far as stop and then turn it back 1/4 turn. Engine stops while idling : Open the low speed screw (L) 1/4 turn. : Turn the idle speed screw (LA) slowly clockwise until the chain begins to run - then turn the screw back 1/2 turn. Chain runs while engine is idling : Open the low speed screw (L) 1/4 turn. : Turn the idle speed screw (LA) slowly counterclockwise until the chain stops running - then turn the screw another 1/2 turn in the same direction. If the chain continues moving when the engine is idling, have your saw checked and repaired by your servicing dealer. Idle setting is too lean: : Turn low speed screw (L) counterclockwise - no further than stop - until the engine runs and accelerates smoothly. It is usually necessary to change the setting of the idle speed screw (LA) after every correction to the low speed screw (L). * see "Guide to Using this Manual" MS 341, MS 361, MS 361 C 45